This is a good example to investigate the effect of rock mass brittleness on pillar strength and the overall behavior of the pillar (change in_weak_multecrit ...
Single-Zone Unconfined Compression Test with IMASS Model · Multi-Zone Confined Compression Test with IMASS Model · Pillar Stability with IMASS Model · Slope ...
Missing: 3dec700/ pillarimass.
It allows for simulation of unconfined or confined compressive strength testing of a single zone. Try turning different flags on or off or changing some input ...
Missing: 3dec700/ pillarimass.
A zone is a closed geometric domain, with nodes at the vertices and faces forming the surface of the zone. The relative orientation of the nodes and faces is ...
Missing: 3dec700/ Imass/ Pillar/ pillarimass.
Feb 25, 2024 · FLAC3D. Base Commands. The main commands used by FLAC3D are encapsulated on the list below. Note these are a mix of FLAC3D-specific commands ...
Missing: 3dec700/ pillarimass.
Feb 25, 2024 · Commands. Operate on zones. Commands listed here: zone commands; zone face commands; zone gridpoint commands; zone interface commands.
Missing: Imass/ Pillar/ pillarimass.
Itasca Software Documentation · Itasca Software Guide · Modeling Methodology · General Approach · FLAC (FLAC2D/FLAC3D) · FLAC Modeling · Introduction · PFC.
Missing: 3dec700/ pillarimass.
FLAC3D Commands and FISH: This section provides the core description of FLAC3D model objects (zones, structural elements, building-blocks, and extrusions) ...
Missing: test3d/ Imass/ Pillar/ pillarimass.
Initialize zone stresses based on the density of the zones above them and gravity. For all zones in the range, the total column of zone densities above them ( ...
Missing: 3dec700/ Imass/ pillarimass.
In order to show you the most relevant results, we have omitted some entries very similar to the 9 already displayed.
If you like, you can repeat the search with the omitted results included. |