Aug 25, 2022 · Hello, I need some help. When I cut in your software, I found the problem of insufficient moving distance. (The following units are mm.)

Mar 5, 2022 · You can try using 'Offset Fill' - The output won't be as clean, but it follows the contours of the shape instead of scanning back and forth.

Apr 30, 2023 · I don't know if my new head is a true 15W opt. output, but I am getting a nice clean cut all the way through 6mm solid birch. I'm running at ...

Dec 5, 2023 · The other problem with it is even if you cut through it, it is more difficult to clean up - it soaks up the soot and the top veneer is so thin ...

Mar 15, 2024 · I have a problem where the lines on my piece have different depths(Material is flat) This problem however only occurred when engraving on ...

Duration: 16:12
Posted: Jan 17, 2024

Duration: 31:38
Posted: Apr 9, 2024

Aug 28, 2021 · What I would like to do to engrave my print & cut targets is to position the laser at either top corner, and then make sure the laser is running ...