I'm in the ER collet chuck group. In my opinion, they are the most accommodating for the hobby guy and cost far less for a set of collets than a 5C system.

Morning, Baron. I'm trying to decide whether I should be offended by the tone of this response. I assure you that I did not make up the information you ...

If you have a threaded spindle instead of a faceplate and don't feel up to turning your own, Beal Tools sells an ER32 collet adapter that screws onto a spindle ...

You can get an ER-32 chuck that can be mounted to a back plate, or a direct mount for D1-3 or 4 for around $90, and an 18 piece ER-32 collet set for under $100.

Jul 16, 2015 · Looked at this ER-32 chuck previously, it is very nice for the price and the through hole in the back should allow smaller stock to pass through ...

Sep 10, 2018 · No, you will need an ER collet holder for them, you can get holders that have a shank which you can put in the 3 jaw chuck though. There are ...

I highly doubt anyone is torquing ER-32 or ER-40 to recommended spec while in the spindle. Need a fixture for the collet chuck to acheive that kind of torque.

Nov 8, 2012 · With all the recent threads on collets, can someone tell me what all different types there are out there readily available?