Pictured is a print where you can see where the nozzle consistently hit the print on the inside of these prints, when travelling back and forward, ...
Nov 15, 2022 · Z-hop will fix it on the travel moves if only a bandaid, sometimes it can be caused by over extrusion causing edges of lines to be higher than ...
Missing: 136u2ug/ | Show results with:136u2ug/
Dec 4, 2022 · This often happens when part of the print gets raised by cooling layers warping lower layers and raising the height.
Missing: 136u2ug/ nozzle_hitting_print_help/
Oct 25, 2022 · How do I remove the filament? I ran it while I was at school and came back to this mess.
Missing: 136u2ug/ nozzle_hitting_print_help/
Aug 23, 2023 · so I think I had a similar issue try squaring the frame of your printer and adjusting the tension on the rollers (if there are any) on where ...
Missing: 136u2ug/ nozzle_hitting_print_help/
r/3Dprinting: /r/3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of…
Missing: 136u2ug/ nozzle_hitting_print_help/
Dec 11, 2023 · Yes for any print where the supports or other thin pieces may flex and get caught. Stringing is the reason I don't use Z hop as a normal ...
Missing: 136u2ug/ nozzle_hitting_print_help/
Feb 18, 2023 · I have been trying to print the cute little octopus on my Neptune 3 but when printing the legs the filament is curling upwards at the edge ...
Missing: 136u2ug/ nozzle_hitting_print_help/
Dec 13, 2022 · Had a go at printing in 0.2 nozzle but it clogged soon into the print and havent been able to unclog it. Any tips for working with 0.2?
Missing: 136u2ug/ nozzle_hitting_print_help/
In order to show you the most relevant results, we have omitted some entries very similar to the 9 already displayed.
If you like, you can repeat the search with the omitted results included. |