May 15, 2024 · I'm just trying to print a cylinder but it will randomly stop extruding and output an awful looking print, it looks like air is getting in ...
Missing: 1csa6r7/ | Show results with:1csa6r7/
6 days ago · Okay, so very long story short. Awhile back, my printer suddenly stopped printing. It would start the print, but the extruder would begin ...
Missing: 1csa6r7/ tpu_is_extruding_properly_after_installing_1mm/
Jan 15, 2023 · Now it refuses to extrude on the right side 1/2 of the bed. After reading some of the comments. I would have to agree that it is the cable. I ...
Missing: 1csa6r7/ tpu_is_extruding_properly_after_installing_1mm/
Apr 24, 2024 · Just a k1. Not a max. I've been busy so I have barely messed with it. But the short amount of time I did, I used tpu. Any tips on making it work ...
Missing: 1csa6r7/ tpu_is_extruding_properly_after_installing_1mm/
Dec 28, 2023 · So l've got a CR10-SE and every time the first layer come out like this. I know it is because the nozzle is to far away from the bed but how ...
Missing: 1csa6r7/ tpu_is_extruding_properly_after_installing_1mm/
Jan 15, 2023 · It seems to be clogging. I say it seems to because after about 30 minutes of printing it just stops extruding anything besides very fine wisps.
Missing: 1csa6r7/ tpu_is_extruding_properly_after_installing_1mm/
Feb 10, 2022 · That said, the cubes edges did not look clean (slight bulging). I also did the extruded filament feed test @100mm of filament: again, spot on ( ...
Missing: 1csa6r7/ tpu_is_extruding_properly_after_installing_1mm/
Apr 18, 2021 · I just got my printer a couple days ago. It came mostly assembled, so I haven't had to do a ton of tinkering and I'm not super familiar with ...
Missing: 1csa6r7/ tpu_is_extruding_properly_after_installing_1mm/
In order to show you the most relevant results, we have omitted some entries very similar to the 8 already displayed.
If you like, you can repeat the search with the omitted results included. |