Aug 24, 2023 · Yeah usually good idea to first check that all connections are plugged in properly and not obstructed. Easy for something to come loose if ...

Oct 19, 2023 · When I put something to print, the nozzle would heat up normally and would even start printing, but a few seconds after a print starts, ...

Nov 25, 2022 · The typos in the image do not inspire confidence in the product, but I'm hoping it's something simple I can do right now to fix it and start my ...

Aug 29, 2023 · Swapped the firing for nozzle and bed as instructed by Elegoo (removed hot glue) both temps seems alright on boot (21 and 22 degrees), after ...

Feb 5, 2023 · As your hot end heats up it gives that feedback to the controller. The message you are getting is a safety message. If the machine is heating up ...

Dec 13, 2022 · I've had the printer for a few days now and I'm at a loss. When I first got the printer I leveled the bed and using a feeler gauge I ...

Feb 2, 2023 · 17hr print fails at 91%. My first 3d printer just arrived, and it is awesome! Huge bed, direct drive, solid speed, under $400. Leveled bed, ...

Feb 17, 2023 · I am printing with esun pla+ 215 first layer 215 print temp. Did a PID tune and e steps / flow calibration 0.2 layer height with Superslicer.