Jun 18, 2023 · Your bed is VERY warped. There are a few things indicating that: your purge line looks like it was printed with the nozzle that's a millimeter ...

Jan 30, 2024 · Hey everyone, I'm recently very frustrated. The first 10 prints with my printer came out very good, everything was nice - not perfect but ...

Mar 26, 2023 · There is a problem with your X axis, it does not move your print head to middle of the bed (the first rattling sound).

May 19, 2023 · Anyways, I go to the printer settings, reset the offset to 0, then try and level the bed with the knobs, but can't. The back left adjustment is ...

Jan 20, 2023 · Recently I had the nozzle clog and I managed to fix that with the provided needle. I decided to re-level the bed and now I get probing errors. I ...

Feb 17, 2023 · I am printing with esun pla+ 215 first layer 215 print temp. Did a PID tune and e steps / flow calibration 0.2 layer height with Superslicer.

Jan 2, 2023 · Given that it is showing up in your support I think it might be a problem with the Z axis. is it showing up at the same height in every ...

Jun 17, 2023 · I've tried leveling the bed, slowing print speed, heating the extruder to 210 from 200. So far, no results and I apologize again if this is ...