Feb 10, 2024 · I ALMOST have my printer back to where it should be. Squared X axis, adjusted POM wheels, loosened lead screws, greased everything, leveled ...

Sep 22, 2022 · that happens when its too close, however i find it weird that it hapens on the 2nd layer and not the first one, what initial and regular ...

Apr 8, 2024 · I needed to swap my nozzle so I heated it up to 200 degrees and tried to unscrew it with the wrench that is included with the printer.

Feb 15, 2024 · Failure pic for attention. What are some setting for a .2 nozzle and silk pla I should know about? I'll do normal 200/60 for the running ...

Feb 22, 2024 · Make sure that you set up your code so that the adjustment knobs match the appropriate location on the actual printer.

Jul 3, 2022 · It is scraped up because I tried to clean it with a brass wire brush and some sandpaper, and then tried to remove it just before posting. But I ...

Feb 12, 2024 · I have leveled repeatedly and even moved the ring to different parts of the bed. But each time I try this it catches on this side.

Nov 9, 2023 · If it does then your nozzle is too loose and needs to be screwed in cause the sensor isn't getting close enough to feel the bed. Heat the nozzle ...