Aug 16, 2008 · I'm looking at getting an ER collet set for my lathe with an MT3 spindle. I was originally going to get an ER32 set however see the same source ...
People also ask
What is er 40?
What is the maximum size of ER32?
What does er stand for in collets?
What is er-32?
May 10, 2009 · So I'm wonder if there is some reason to get ER40 vs ER32 and a seperate 1" end mill holder. Do the ER40's hold better on say 1/2" shanks? FWIW, ...
Missing: 163461/ | Show results with:163461/
Sep 4, 2012 · There is a thread over in the Gunsmith section with some info. One thing the 5C will do that the ER's will not, is allow you to grip and release ...
Missing: 163461/ | Show results with:163461/
Sep 25, 2020 · I went with ER40 as my lathe has a 1.5" spindle bore so I can use the larger size. For the mill, I rarely go above 3/4" though.
Missing: 163461/ | Show results with:163461/
Mar 21, 2009 · I just got a pair of er-32 collet chucks (NMTB40 and R8) from Maritool- lovely, can't wait to start using them. I went that route so I could ...
Missing: er40. 163461/
Nov 6, 2012 · The ER32 series has a capacity of .02-.787 inches. ER40 range is .094-1.024 inches. The answer depends on what range you need.
Missing: 163461/ | Show results with:163461/
Jan 19, 2007 · Mari, quick question about the balance rating on your Super Precision CAT40 ER32 holders: The info says balanced to 16000rpm.
Missing: v- 163461/
Aug 21, 2009 · Looking for a set of ER32 Collets Need Inch & Metric. Nicer is better but price is a consideration. Looked at Ebay & Maritool already.
Missing: 163461/ | Show results with:163461/
Oct 7, 2004 · Michael, I'm quite sure all er collets are interchangeable. I'm sure you realize though that you can't use a er16 collet in an er 32 holder.
Missing: 163461/ | Show results with:163461/
In order to show you the most relevant results, we have omitted some entries very similar to the 9 already displayed.
If you like, you can repeat the search with the omitted results included. |