I would like to use 2 dimensional milling to cut a wood frame to carry the concrete grow modules and hide the electronics. There will be a small cut-out on one ...

I wanted to make a work that appeared to be a single surface looped around and around like a coil or a spring. I like to make things that use machines ...

First load the material into the machine. Release the clamp in the back. Align the sheet to the far left, parallel to one of the vertical lines along the front ...

#electronics #cut2d #elecFab · Twitter Facebook Google+. This dance is as follows: mill, solder, wire. Familiar aesthetic for the board. Milling the traces at ...

In photoshop, I resized the image and converted it to a bitmap. Within the bitmap settings there are a number of different methods, each producing different ...

Okay, back in the lab today and the laser cutter is free. First, I will build a prototype from cardboard. Cardboard cuts fast. Cardboard is cheap. Cardboard is ...

I was introduced to a project by Enrico Bassi which uses two ATMega boards connected to IR Sensors and IR LEDs to network by reading pauses in IR light ...

Relatively simple schematic. One thing to be aware. The phototransistor is directional. You can check the datasheet for that. Hint the chamferred corner aligns ...

I need to export the board design from EAGLE, generate the mill paths and solder the electronic components. The board is ready to be cut; EAGLE's job is ...

Apr 23, 2017 · I wanted to improve several aspects of the first prototype. One, the robot should be easily portable, which I think works best if it can be ...