Jan 21, 2019 · As part of the build, I'm planning to add a pair of cedar stringers on either side of the centre one, which is already in place. I was just ...

Jun 5, 2011 · When I draw the template onto the 6' 2" blank, I go 12" from the nose and measure half of 14" on each side of the stringer. I do this for ...

Apr 4, 2005 · I'd split it and glue the stringer first. You might also consider running some masking tape along the cut each side/top & bottom so glue doesn't ...

Mar 20, 2004 · Try to use your planer as much as possible on the rail bands and continue them up into the stringers. When you screen your rails you will find ...

May 18, 2015 · I have a brand new block plane (albeit from Home Depot and not a shaper supply store), and I did manage to get a few epic full-board curly-Q ...

Oct 18, 2011 · The cracks on each board are located around the center of the board and are about a finger nail thickness in width. The foam is not affected.

Jun 20, 2006 · A typical 6'2 blank has a 1mm laminated stringer, while a 7'6 will have a 3mm stringer, which is equal to a much wider peice of straight grained ...

Jan 22, 2008 · Hi Guys, I am planning a new board, a 9ft wooden old school mal, a rideable wallhanger for my parents new house. I remember seeing at some ...